BendPak LR-60

Authorized Dealer

• Low-Profile Design – A low 4” collapsed height accommodates most vehicles.


• Single-Point Safety Release - The single point safety release and dead-man style operation controls makes the LR-60 lift easy to operate and safe to use.


• Dropped Crossbar – A specially formed crossbar is dropped in the center providing added clearance for vehicle drive-over clearance.


• Rugged Steel Channel Frame


• Industrial-Grade Hydraulic Cylinder – Integrated into the single hydraulic cylinder is a one-piece, pilot fitted, machined steel piston wrapped with specially designed, pressure loaded U-cup piston seals, backups and wear bands that virtually eliminates any fluid bypass. The micro-smooth chrome-rod is machined from high yield, ground & polished C-1045/50 micro-alloy steel and plated to a minimum of .001˝ diametrically, to ensure superior cylinder operation and life. Specially designed, high durometer, mechanically loaded rod seals virtually eliminate rod seal leakage and a specially formulated abrasion resistant urethane rod wiper provides exclusion protection. The welded cylinder body is made from high yield-strength steel tubing produced to exceed ASTM specifications. This combination of superb base material and superior processing ensures straight, smooth and long duty life cylinders. An integrated flow restrictor provides a controlled descent in the case of an unexpected hose rupture.


• Durable Powder Coat Finish – All Low-Rise lifts feature a durable powder coat finish that gives the metal a high-quality, extremely durable finish which can withstand even the harshest environmental or chemical conditions. Unlike other companies that claim to powder coat, we take pride in our meticulous 10-step process. First, all parts are visually inspected then sandblasted. After, the parts are washed in our five-stage phosphate tanks that can accommodate parts up to 25’ long. Once cleaned, they’re immediately dried, to avoid rust production then outgassed. Outgassing is a process we take pride in which pre-bakes the parts in a curing oven, reducing the possibility of blemishes that may be hiding in the pores of the metal. If not properly outgassed, imperfections in the metal may bubble during the curing process and most likely cause chips in the powder. After the parts are washed and outgassed, any surfaces and/or threaded holes that need to be masked or plugged are done so with high-temperature masking tape and silicone plugs. Next, the parts are given a quick thinner wipe to remove any light debris or fingerprints then hung on an electrostatically grounded conveyor line. The powder is then applied using an electrostatic spray gun. The powder “sticks” to the parts similar to how dust sticks to a television screen. Once the parts are powder coated, the carts are rolled into our curing oven and baked at 400 degrees for 15 for 45 minutes.


• Solid Rubber Lift Blocks – Others charge extra for these necessary adapters but they’re standard with every LR-60 lift.


• Detailed Safety Instruction – Included with every lift are detailed installation and maintenance instructions, graphic safety and maintenance decals, and a vehicle lifting point guide and safety instruction placard that helps train personnel on proper safety and maintenance guidelines.